Boost Leash Gear Based Electronics Boost Controller BLGB

Gear Based Boost Leash Controller for 1-6 gear applications. For clutch transmission cars and motorcycles. Simple 4-5 wire hook-up, Ign voltage, ground, scramble ,clutch switch input and auxiliary shift input.

The controller can run on CO2 or manifold pressure. It has a launch psi setting, number of gears setting, plus PSI and rate for each gear. The way it works is when the clutch is held for more than 1 second it resets the gears to gear1 and puts the controller in the launch mode.

When the clutch is released, the controller goes into gear 1 mode and each time the clutch is pressed it goes to the next gear until the final gear is reached. It only upshifts. The controller also has an optional shift input that can be connected to air shifter controllers to upshift with an air shifter setup.

So to reset down to 1st gear you hold the clutch for over 1 second and it goes back to gear 1. The controller also has automatic activation so you don’t need a separate activation switch. When the controller senses more than 2psi boost then it becomes active and runs whatever is programmed.

Note: we stock black powder coat standard, other colors available by special order.