Blank Universal Fit Motor Plate for Small Block Ford with Belt Drive, No Engine Offset VR1100030
$175.00 – $212.00 Each - Free Shipping
Vincent Racing 1/4″ Blank Outer Universal Fit Front Motor Plate Kit for Small Block Fords. CNC Cut out for belt drive applications and choice of spacer setup for different belt drives and blocks.
This Motor Plate is 36″ wide giving you ample width to fit a wide range of applications. You trim the width to fit your vehicle.
- 1/4″ Thick 6061 T6 Aluminum
- Small Block Ford 302/351 Windsor
- 36″ Wide, 9.5″ Tall, 1.625″ from top to inside upper radius of belt drive cutout.
- On Center -Zero Engine Offset (Belt Drive Cutout is on center)
- Important: If you choose ON CENTER, you need the motorplate, midplate, transmission mount, center tunnel and pinion all ON CENTER for proper driveline alignment!
- 3/4″ OD Spacers for Belt Drive Clearance Included (if belt drive requires them)
- Optional 5th 3/4″ OD Spacer +.250″ to go behind crank trigger mount 2nd Hole
- Jesel KBD-34175 belt drive does not require any spacers.
*Some Ford SVO blocks required drilling lower bolt hole in plate to 3/8″
Spacer Length Chart
| Belt Drive | Spacer Length |
|---|---|
| Jesel KBD-34175 | No spacers needed |
| Jesel KBD-34170 | 1.00″ |
| Danny Bee #2513 billet cover * | 1.45″ |
| Innovators West 5300 & Old Danny Bee w/cast cover | 1.50″ |
| *when using included water pump spacers | |
| Spacers | No Spacers, 1.00" – Jesel KBD-34170, 1.45" – Danny Bee Billet #2513, 1.50" – Innovators West 5300, Cast Danny Bee |
|---|
Be the first to review “Blank Universal Fit Motor Plate for Small Block Ford with Belt Drive, No Engine Offset VR1100030”
You must be logged in to post a review.
Customers also purchased...
$78.99 Set
Reviews
There are no reviews yet.