For Applications Listed Below Using Factory Spindles
1979-1987 Regal
1982-2002 S10 / S15 (2 wheel drive)
1979-1987 Malibu / El Camino
1979-1988 Monte Carlo
1979-1988 Cutlass
1982-1986 Bonneville
1979-1987 Grand Prix
1979-1981 Lemans
Evolution S 11″ Dynamic Drive Mount (DDM) Stainless Steel Rotors – B2788AS
- DDM system secures the rotor and allows for rotor thermal expansion – drastically reducing warping, coning, and cracking which are common with bolt retention designs
- DDM billet aluminum hat design is secured by an internal Spirolox, eliminating heavy bolts and hardware- further reducing rotating weight
- Evolution S rotors are machined and fully ground from Stainless Steel that exhibits 48% greater yield strength at 1,000° F compared to carbon steel- further maintaining rotor integrity
- Stainless steel Evolution S rotors are highly resistant to heat and corrosion
- Unique Aero Slot design reduces rotating weight and promotes even heat dissipation- compared to common round drilled holes
- Scalloped design further reduces rotating weight
- 11″ O.D. / .280″ thickness (Discard at .260″)
Two Piston Billet Evolution 2 Caliper – B2570
- Compliance decreases 5% vs Pro Series
- Computer finite element analysis (FEA) optimized and field-tested caliper
- Evolution 2 design improves piston retraction, pedal feel, and stiffness
- High retraction piston and O-ring design to eliminate drag during acceleration
- Results in improved pad wear and exemplary braking efficiency
- Stainless steel pistons mitigate heat transfer to brake fluid
- Reverse dish pressure vessel piston maximizes stiffness
- Pistons are 1.750″ for increased clamping force
Billet Aluminum Caliper Mounts
- One piece design eliminates spacers & bolts that require periodic maintenance
Billet Aluminum Hubs
- Strong lightweight aerospace material
- Profile milling results in extensive weight reduction
- Low friction ball bearings
- Factory greased for optimal metering
- Low friction seals & stainless seal rings
- Options include ceramic ball bearings & high resolution wheel speed sensor kit
Screw-in Wheel Studs
- Tapered allen 1/2″-20 x 2 1/2″
- Standard allen in 3″ available on request
DTC-30 Semi Metallic Brake Pads – B2510
- Provides the best starting-line cold holding power
- Recommended for vehicles going 150 MPH or less in the 1/4 mile
Reviews
There are no reviews yet.